How to wrap a snowboard with vinyl
Line up the snowboard wrap with its backing still on. Then apply it in sections, trim it to fit, and clear the binding mounts.
Cut the vinyl to fit the topsheet, the upper face of your board. Leave the base and steel edges bare.
What you need
- A wrap that fits your board, plus the film maker’s guide.
- A clean, stable work surface and lint-free cloths.
- The cleaner, tape, and cutting tool your wrap guide calls for.
- A squeegee, a flat tool that presses film onto the board.
- The tools and manuals for your board and bindings.
1. Check the board and clean the top
Make sure your wrap works with the board’s finish. Ask the maker first if the surface has deep chips or a layer that is peeling.
Take a photo of each binding to record its spot and angle. Remove the bindings as your manuals direct. Use the cleaner your film maker lists. Let the surface dry fully. Check the film guide for the room and board temperature.
2. Line up the sheet before you peel
Do a dry fit. This means you set the sheet on the board with the backing still on. Mark the nose and tail at the edge of the sheet with removable tape. Check that you have extra film past both ends and both sides.
Look at where the bindings will sit. Check that the part under your boot will not cover any words you want to show. You can preview your design for free in 2D and 3D before you choose where to place it. Use your board to check the final fit.
3. Stick down one half at a time
Use this method if your film is made to go on dry and the maker allows a tape hinge.
- Tape across the middle of the sheet so it stays in place. Fold one end back over the tape.
- Peel back a small part of the backing. Use the squeegee to press the film down from the middle toward the sides.
- Pull back more backing as you work toward the tip. Let each stroke overlap the last one.
- Remove the tape. Repeat on the other half.
If a fold or bubble forms, stop and check your film guide. Some films let you lift and lay them again. Use heat or make a hole in a bubble only if your film maker tells you to.
For an example of a tape hinge, see Avery Dennison’s film application guide (PDF). Its settings apply to the film in that guide.
4. Trim the wrap and open the mounts
Follow the wrap guide for the cut line and tool. Take short cuts and avoid cutting into the board. Check for loose film at the tips and along both sides.
Clear the mounts used by your setup. These may be threaded holes or slots. Keep scraps out of the holes and clear any part of a slot your hardware needs. If you cannot see where a mount starts, stop and check your board manual before you cut.
5. Refit the bindings and check the edges
Check how long the film maker says to wait before you ride. Press and check the edges as the film guide directs. Refit the bindings with the parts and steps in your manuals.
For Burton gear, see Burton’s binding mount guide. If film blocks a mount or lifts near an edge, fix it before you ride.
Frequently asked questions
Do I need to remove the bindings to wrap a snowboard?
Yes. Photograph each binding's position and angle, then remove them as your manual directs so the film can cover the whole top.
Can I wrap a snowboard at home?
Yes, with a clean and stable work surface, a squeegee, a cutting tool and the film maker's guide. Work at the room and board temperature the guide lists.
How do I get bubbles out of a snowboard wrap?
Stop and check your film guide. Some films can be lifted and laid again. Use heat or pierce a bubble only if the film maker says to.
Does the wrap go over the edges or the base?
No. It covers only the topsheet. Leave the base and steel edges bare so waxing, tuning and edge grip work as before.
How long should I wait before riding a wrapped board?
Follow the waiting time the film maker gives. Then press and check the edges and the mounts, refit the bindings and check them before you ride.